FOLD FLAT BOX CARD Directions.
Card base - 2 x ( 5 7/8" x 4 1/8") cardstock. Score with the long side up @ 1/2" - 1"; turn 180% and repeat score lines. Repeat scores on 2nd piece. Round all corners. Before burnishing score lines on Oval front card - **adhere DSP 1 x (3 5/8" W x 3 7/8" H) to card front section between the score lines. Place desired size framelit Oval and run through Big Shot. ** Card Back/ inside - adhere DSP 1 x (3 6/8" W x 4" H) to inside card between the score lines. Turn over back section and stamp a greeting. (as you would inside a normal card.) Decorate the inside scene as you wish, with fox and trees, or heat embossed greeting as above. Burnish score lines in 'Hills and Valleys' folds on both the card front and back. Run Fuse along the 1/2" flaps on left and right side of the card back. Join front to back, lining up outer edges and rounded corners. Decorate front as desired.
Square cut out front card same dimensions as above. DSP - same dimensions as above. Continue ** DO NOT adhere DSP just yet. Lay DSP on card front; place graduating square framelits until you are happy with the look. 1 larger & 1 smaller. Place small amount of Snail to reverse of DSP in the centre, and layer on cardstock; place smallest square framelit in desired place and run through Bigshot. Remove smallest cut out section. Lift off front DSP piece and place largest square over small hole in DSP, line up and run through Bigshot, DSP only. Replace onto cardstock and frame will be created. Adhere DSP to card front. ** Continue as above.
Both cards will lay flat for C6 envelopes.
Card back can be completely in Whisper White, making stamping and writing a message easier, or not, your choice. Happy Stampin' Louisa
No comments:
Post a Comment